User's Manual

102

CONNECTIONS AND MAINTENANCE

./4%FOR.-%!)N/UTAND!&/UTLEADS

The connectors are attached to keep the leads together.

Before connecting to a piece of equipment, you should cut

the leads to remove the connector.

t DC POWER CONNECTOR

Connects to a 13.8 V DC power source.

#!54)/. After connecting the DC power cable, NMEA

leads, external speaker leads and Hailer leads, cover the

connector and leads with an adhesive tape, as shown be-

low, to prevent water seeping into the connection.

Rubber vulcanizing

tape

y NMEA 2000 CONNECTOR

Connects to the NMEA 2000 network.

u COMMAND MICROPHONE JACK

Connects to the optional Command microphone. (p. 106)

D Connect to the MA-500TR

Connect the transceiver to the high-density D-Sub 15-pin

connector of the MA-500TR using the OPC-2014* cable. Af-

ter connecting, an Individual DSC call can be made to the

AIS target using the transponder without entering the target’s

MMSI code.

* The OPC-2014 is supplied with the MA-500TR

s,ISTENER!$ATA(LEAD9ELLOW

Connects to lead 3 of the OPC-2014.

s,ISTENER"$ATA,LEAD'REEN

Connects to lead 2 of the OPC-2014.

s4ALKER!$ATA(LEAD7HITE

Connects to lead 5 of the OPC-2014.

s4ALKER"$ATA,LEAD"ROWN

Connects to lead 4 of the OPC-2014.