User's Manual

6
2
PANEL DESCRIPTION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
!2 CHANNEL NUMBER READOUT
Shows the selected operating channel number.
 s7HENASIMPLEXCHANNELISSELECTEDh!vAPPEARS
!3 CHANNEL NAME FIELD
The channel name appears, if programmed. (p. 13)
!4 KEY ICON (p. 7)
Shows the programmed function of the soft keys on the
front panel.
!5 TIME ZONE INDICATOR
Shows the current time when a GPS receiver is con- ±
nected, or the time is manually programmed.
  s7HEN THE '03 CURRENT TIME IS INVALIDhv WILL BLINKEVERY
2 seconds instead of the current time. After 23.5 hours has
passed, “NO TIME” will appear.
  shv will blink every 2 seconds instead of the current time,
after 4 hours have passed from when the time was manually
programmed. The manually programmed time is held for only
23.5 hours, and after that, “NO TIME” will appear.
“LOCAL” appears when the offset time is set. ±
“MNL” appears when ±
the time is manually programmed .
“UTC” appears when ±
the GGA, GLL or GNS GPS sen-
tence format is included in the GPS signal.
The date information appears when ± the RMC GPS sen-
tence format is included in the GPS signal.
“NO TIME” appears when no GPS receiver is connect- ±
ed, and no time is manually input.
!6 POSITION INDICATOR
± Shows the current position when a GPS receiver is
connected, or the position is manually programmed.
  s7HENTHE'03POSITIONISINVALIDhvMAYBLINKEVERYSEC-
onds instead of position. The last position is held for only
23.5 hours, and after that, “NO POSITION” will appear.
  s hvWILLBLINKEVERYSECONDSINSTEADOFPOSITIONAFTERHOURS
have passed from when the position is manually programmed.
The manually programmed position is held for only 23.5 hours,
and after that, “NO POSITION” will appear.
± “NO POSITION” appears when no GPS receiver is
connected, and no position is manually input.
!7 COURSE INDICATOR
Shows the course of your vessel.
!8 SPEED INDICATOR
Shows the speed of your vessel.
!9 SCAN INDICATOR
“SCAN 16” appears during a Priority scan; “SCAN” ap- ±
pears during a Normal scan. (p. 17)
“DUAL 16” appears during Dualwatch; “TRI 16” appears ±
during Tri-watch. (p. 18)
@0 LOCAL ICON (p. 11)
Appears when the Attenuator function is turned ON.