User's Manual

82
9
AIS Receiver (Depending on versions)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
D Target list display
In the plotter display, push [DISP] to switch to the target list
display, which shows all AIS targets being detected by the
transponder.
The AIS target data is sorted by the distance from your ves-
sel, and the closest target is located on the top of the list.
s Push [∫] or [√] to select an AIS target.
s Push [INFO] to display the detail screen of the selected AIS tar-
get. (p. 83)
s Push [DSC] to transmit DSC call to selected AIS target.
q
w
q THE NUMBER OF TARGETS
Shows the number of AIS targets which are being detected
by the transponder.
w TARGET INFORMATION
Shows the following AIS target information:
 s--3)CODEORNAME, if the name is programmed.
 s2ANGE2.'FROMYOURVESSELTOTHETARGETUNITNAUTICALMILE
 s"EARING"2'FROMYOURVESSELTOTHETARGETUNITDEGREE
D Danger list display
In the target list display, push [DISP] to switch to the dan-
ger list display, which helps you to find any dangerous target
whose CPA is within 6 nm (nautical miles) and TCPA is within
60 minutes of your vessel.
s Push [∫] or [√] to select an AIS target.
s Push [INFO] to display the detail screen of the selected AIS tar-
get. (p. 83)
q
w
q THE NUMBER OF DANGEROUS TARGETS
Shows the number of AIS targets which are being detected
by the transponder.
w DANGER TARGET INFORMATION
Shows the following dangerous target information:
 s--3)CODEORNAME, if the name is programmed.
 s#0! #LOSEST0OINTOF!PPROACHUNITNAUTICALMILE
 s4#0!4IMETO#0!UNITMINUTE