Instruction Manual

19
8
SET MODE
8
18
17
16
15
14
13
12
11
10
9
7
6
5
4
3
2
1
Power Save “ ”
Turns the Power Save function ON or OFF.
OFF: The function is OFF.
ON: The Power Save function reduces
current drain by deactivating the
receiver circuit of the transceiver at
specied intervals.
CH Display “ ”/“ ”/“ ”
Selects the number of digits to display the
channel number. You can select settings
for each channel group.
3d: The channel number is displayed in 3
digits, such as “78A.”
4d: The channel number is displayed in 4
digits, such as “1078.”
Float’n Flash “ ”
Turns the Float’n Flash function ON or OFF.
You can easily retrieve the transceiver from
the water.
L This function works even if the transceiver
is turned OFF.
OFF: This function is OFF.
ON: The backlight, LED, or both of them
send out intermittent light when the
transceiver is oating on the water.
Float’n Flash Alarm “ ”
Selects whether or not an alarm sounds
while the light blinks when the transceiver
is oating on the water.
OFF: The alarm does not sound.
ON: The alarm sounds while the light
blinks when the transceiver is
oating on the water.
Float’n Flash Power Save “ ”
Turns the Float’n Flash Power Save
function ON or OFF.
OFF: This function is OFF.
ON: When the transceiver oats on the
water, it enters the Float’n Flash
Power Save mode to conserve
battery power.
Low Battery Alarm “ ”
Selects whether or not an alarm sounds
when the battery is low. A beep sounds
every time the battery indication is lower
than a displayed value. The beep interval
changes, according to the number of bars
displayed.
L The beep and interval can be changed.
OFF: This function is OFF.
1: A beep sounds when the battery
indication displays no bars.
2: A beep sounds when the battery
indication displays one bar or less.
3: A beep sounds when the battery
indication displays two bars or less.
Delay Timer Subfunction “ ”
Sets the Delay Timer Subfunction to 10,
30, 60 seconds, or OFF. A sub function is
turned OFF after the set period of time has
passed after releasing a specic key.
L When the timer is set to OFF, the sub
function is turned ON until any key is
pushed after releasing the specied key.
L See page 13 for details.
Auto SP Line Convert “ ”
Turns the Auto SP Line Convert function
ON or OFF.
L When this function is OFF, the speaker is
converted into a microphone by pushing
[VOL/SQL] while holding down [PTT].
OFF: This function is OFF.
ON: Automatically converts the speaker
into a microphone, when the
transceiver is oating on the water.