Operation Manual

ManualsBrandsIcom ManualsAudioi703

SCAN OPERATION

q Select VFO mode.

w Select the desired operating mode.

•The operating mode can also be changed while scan-

ning.

e Set [SQL] open or closed.

• See page a left for squelch condition.

r Select S2.

• Push [DISPLAY] once or twice to select S.

•Push [MENU] one or more times to select S2.

t Push [(F-1)SCN] to start the scan.

• Decimal point blinks while scanning.

y When the scan detects a signal, the scan turns

OFF, pauses or ignores it depending on the re-

sume setting and the squelch condition.

•During scan [TS] can be used only when resume is ON.

u To cancel the scan push [(F-1)SCN].

NOTE:

If the same frequencies are programmed

into the scan edge memory channels 1A and 1B,

programmed scan does not start.

VFO A

53792040

60dB

USB

S2 SCN PRI V/M

Select

VFO mode

F-1

then push [(F-1)SCN]

[DISPLAY]

[F-1]

[MANU][SQL]

■ Programmed scan operation

q Select memory mode.

w Close the squelch with [SQL].

e Select S2.

• Push [DISPLAY] once or twice to select S.

•Push [MENU] one or more times to select S2.

r Push [(F-1)SCN] to start the scan.

• Decimal point blinks while scanning.

t When the scan detects a signal, the scan stops or

pauses depending on the resume setting.

y To cancel the scan push [(F-1)SCN].

NOTE:

Two or more memory channels must be

programmed for memory scan to start.

S2 SCN

SEL V/M