SECTION 11 INST UNPACKING: Carefully: remove yolk ‘transceiver: from the packing carton and examine it:for signs of shipping damage. Should any be apparent, notify ‘the delivering carrier or dealer immediately, stating the full extent of the damage. 1t is recommended you keep the shipping cartons. -in:the event storage, moving; or reshipment becomes necessary; they come unhandy. Accessory hardware; cables; etc are prepacked the transceiver. Make stare ol have not overlooked anything. 1.
‘the BE coaxial connector on: the rear chassis mates with & standard PL:258 connector. Some models may: have metric threads. many event, the RE connector will mate with almost PL-259 connector care (5 taken to seat it property.
i i i SECTION, IV OPERATION ' INITIAL PREPARATIONS: Make sure the power switch is in the OFF position, then connect the power supply trod to the power cannector..The red lead should connectable to: the positive side of the powerhouse and the black lead to the negative side. In the event that these leads are improperly ‘connected. the transceiver will not Unction, . Reversing polarity will blow out the fuse in the power supply cord die Yo actuation of the protective circuit.
4. Mount diodes corresponding to the chosen channel, using the BCD number, when: 17 = diced mourned; and 707 = diode not mounted. The: first digit of the BCD corresponds to the First row (N= 1), where is next to the 10-pin connector on the MART X board, the second digit of the BCD corresponds to the second row (N = 2). the third digit, to the third row and soon. Far For Receive i Tramming Complete programming for additional desired channels in the same manner.