Operation Manual

38
7
SCAN OPERATION
7
■ Scan start/stop
D Preparation
Scan resume condition (p. 42); program the scan edges
(pgs. 39, 40); program 2 or more memory channels (pgs. 25,
26); set skip settings, if desired (p. 41).
D Operation
q Select VFO mode for full/programmed scan with
[V/MHz ]; or memory mode for memory scan with
[M/CALL ].
•Select the desired bank with [BANK ] for bank scan.
w Set the squelch to the point where noise is just muted.
e Push [V/MHz ] for 1 sec. to start the scan.
•To change the scanning direction, rotate [DIAL].
•The memory channel readout blinks the scan type as follows:
r Push [SET ] to switch full and programmed scan
(P1, P2 and P3).
t To stop the scan, push [SET ] or [V/MHz ].
z Push [VFO/LOCK] to select VFO mode for
full/programmed scan; push [MR/CALL] to se-
lect memory mode for memory scan.
• Push [BANK/OPTION] to select a bank for bank
scan.
x Set the squelch to the point where noise is just
muted.
c Push [
SCAN 2(T-SCAN)] to start the scan.
• Push [
YY
] or [
ZZ
] for 1 sec. also starts the scan.
v Push [ SET B(D-OFF)] to switch full and pro-
grammed scan (P1, P2 and P3).
b To stop the scan push [
SCAN 2(T-SCAN)] or
[
CLR A(MW)].
SCAN
2
SET
B
SCANLOCK
LOCK
SCAN
OPT
PRIO
SCAN
LOCK
S E T
ANM
MONI
DUP
LOW
T
-
SCAN
TONE
PRIO
M/CALL
SCAN
V/MHz
DIGITAL
PRIO
AO
BUSY
MUTE
NAR
MID
LOW
LOCK
S E T
ANM
MONI
DUP
LOW
T
-
SCAN
TONE
PRIO
M/CALL
SCAN
V/MHz
DIGITAL
PRIO
AO
BUSY
MUTE
NAR
MID
LOW
LOCK
S E T
ANM
MONI
DUP
LOW
T
-
SCAN
TONE
PRIO
M/CALL
SCAN
V/MHz
DIGITAL
PRIO
AO
BUSY
MUTE
NAR
MID
LOW
LOCK
S E T
ANM
MONI
DUP
LOW
T
-
SCAN
TONE
PRIO
M/CALL
SCAN
V/MHz
DIGITAL
PRIO
AO
BUSY
MUTE
NAR
MID
LOW
• During full scan • During programmed scan • During memory scan • During Bank scan
Indicates scan edge channels.
• P1 stands for 1A/1b
• P1 to P3 are available when
they are programmed, and
switches with .
Push to select full,
band* (A1, AA) or programmed
scan (P1, P2 and P3) in se-
quence.
LOCK
SET
( )
LOCK
SET
( )
A1 : FM band (136–174 MHz)
AA : AM band (118–136 MHz)
(*Depends on versions)
When AM and FM frequencies are programmed into memory
channels in a disorderly fashion, memory scanning is very slow
because it takes a lot of time to change Modes.
To increase memory scanning, assign AM and FM frequencies
into separate banks respectively and use Bank Scan.