User Guide

71
12
DIGITAL MODE OPERATION
DD
Message Transmission
Select the Message transmission function ON and OFF.
When ON is selected, transceiver transmits a text message
(pre-programmed).
(default: OFF)
After the manual transmission (pushing [PTT]), the Message
Transmission setting is return to OFF automatically.
DD
TX message
TX messages are available up to 6 channels and each chan-
nel can be programmed up to 20 characters message. Avail-
able characters are 0 to 9, A to Z (capital letters only), some
symbols and space. (shown at right table)
DD
TX message programming
A TX message channel C1 must be programmed, if you want
to use the GPS message. The GPS message is transmitted
from channel C1 only.
q Push [MONI] (or [SET]) to edit for 1 sec. then rotate
[DIAL] to select the message channel.
• One of either “C1” to “C6” flashes.
w Push [MONI] (or [SET]) to set into message programming
condition.
• The 1st digit blinks and channel indication stops blinking.
e Rotate [DIAL] to set the desired character.
r Push [MONI] (or [SET]) to select 2nd digit, then rotate
[DIAL] to set the desired character.
• 2nd digit blinks (1st digit stop blinking).
• Repeat this step for programming.
t Push [V/MHz] to set the message.
y Repeat steps w to t to set another message channels.
u
Push any key other than indicated function keys to exit the
option set mode.
LOCK
S E T
ANM
MONI
DUP
LOW
T
-
SCAN
TONE
PRIO
M/CALL
SCAN
V/MHz
DIGITAL
PRIO
AO
BUSY
MUTE
NAR
MID
LOW
LOCK
S E T
ANM
MONI
DUP
LOW
T
-
SCAN
TONE
PRIO
M/CALL
SCAN
V/MHz
DIGITAL
PRIO
AO
BUSY
MUTE
NAR
MID
LOW
LOCK
S E T
ANM
MONI
DUP
LOW
T
-
SCAN
TONE
PRIO
M/CALL
SCAN
V/MHz
DIGITAL
PRIO
AO
BUSY
MUTE
NAR
MID
LOW
(3)
(D)
(N)
(X)
(+)
(4)
(E)
(O)
(Y)
(–)
(5)
(F)
(P)
(Z)
(✱)
(6)
(G)
(Q)
(/)
(7)
(H)
(R)
(,)
(8)
(I)
(S)
(space)
(9)
(T)
(0)
(A)
(U)
(1)
(B)
(V)
(2)
(C)
(J) (K)
(L)
(M)
(W)
(.)
(
))(( )(’)(&)( % )($)(#)(!)
(<)(:) (;)
(=)
(>)
(?)
(@)
([)
(\)
(])
(^)