User Guide

PANEL DESCRIPTION

!1 PRIO/SET•P KEY*

(PRIO/PRIO Set)

➥ Push to select the priority channel. (p. 13)

➥ Push and hold for 2 sec. to set the displayed channel as

the priority channel. (p. 13)

(S-Ring/PRIO Clear)

➥ Push to transmit the Smart-Ring signal. (p. 30)

• When RX channel is selected, “N/A” appears.

➥ Push and hold for 2 sec. to cancel the priority channel

setting. (p. 13)

!2 LOW/“”KEY*

(RF Power/Lock)

➥ Push to toggle the transmit output power level. (p. 11)

➥ Push and hold for 2 sec. to electronically lock all keys

except the following (p. 14):

[PTT], [Side1] (Monitor), [Top] (Function), (Call)

and (Lock)

Push and hold for 2 sec. again to turn the lock function

OFF.

(Dup/Zone)

➥ Push to toggle the selected channel between duplex or

simplex operation. (Depending on pre-setting)

• Duplex operation can be selected in ‘CB-R1’ to ‘CB-R8’ only.

➥ Push and hold for 2 sec., then select the desired zone

with [CH Up] or [CH Down]. (p. 11)

• Available only when more than two zones are set.

■ Function display

q TRANSMIT INDICATOR

Appears while transmitting.

w BUSY INDICATOR

Appears while the channel is busy.

e SIGNAL STRENGTH INDICATOR

Indicates relative signal strength level.

• “”blinks when the ATS function is in use. (p. 30)

r TONE INDICATORS (p. 23)

➥ “T” appears while the Subaudible tone encoder is in use.

➥ “T SQL” appears while the Tone squelch/DTCS squelch

function is in use.

q w r oiuye

!1 !4 !5 !6!3!2