Operation Manual

113
9
SCAN OPERATION
q Select VFO mode, then set a frequency.
w Close the squelch with [RF/SQL].
e Set the desired memory channel as the channel to
be watched.
r Select
SS
-- 22
.
t Push [F-2
PPRRII
] to start the priority watch.
•“ ” appears and decimal points blink while watching
VFO, and then “ ” and decimal points blink while
watching a memory channel.
y When the scan detects a signal, the scan pauses
for 10 sec. or until the signal disappears, depend-
ing on the resume setting.
u To cancel the scan push [F-2
PPRRII
].
NOTE: The paused condition when detecting a sig-
nal differs depending on the scan resume condi-
tion. (p. 132)
resume on: pauses for 10 sec.
resume off: pauses until the signal disappears.
Select
VFO mode.
Select watching
channel.
Push [F-2 PRI].
[MENU/GRP] [F-2]
[RF/SQL]
Appears while scanning
q Select
SS
-- 22
.
w Push [F-3
VV//MM
] to select memory mode.
e Close the squelch with [RF/SQL].
r Push [F-1
SSCCNN
] to start the memory scan.
•Decimal point blinks while scanning.
t Push [F-2
SSEELL
] to change the memory scan to se-
lect memory scan.
y When the scan detects a signal, the scan stops or
pauses depending on the resume setting.
u To cancel the scan push [F-1
SSCCNN
].
NOTE: Two or more memory channels must be
designated as select memory channels for select
memory scan to start (see p. 104).
While scan function is not active, pushing [F-2
SSEELL
] sets the select memory channels ON or OFF.
And pushing and holding [F-2
SSEELL
] for 2 sec.
clears the all select memory channels.
Designate
“★.”
Select
memory mode.
Push [F-1 SCN],
then push [F-2 SEL].
[MENU/GRP] [F-1] [F-2] [F-3]
[RF/SQL]
■ Select memory scan operation
■ Priority watch
Menu group selection
Push [MENU/GRP] for 1 sec.
Selection from:
MM
,
SS
or
GG
(Graphic)
Menu selection (Example: M)
Push [MENU/GRP] momentarily.
Selection from:
SS -- 11
,
SS -- 22
or
SS -- 33
Either
Y or Z
Either
Y or Z