Operation Manual

128
13
SET MODE
13
■ Miscellaneous (others) set mode
3
BBeeeepp((CCoonnffiirrmmaattiioonn))
A beep sounds each time a switch is pushed to con-
firm it. This function can be turned OFF for silent op-
eration.
The volume level can be set described below.
OONN
Confirmation beep ON
(default)
OOFFFF
Confirmation beep OFF
4
BBeeeepp((BBaanndd EEddggee))
A beep sounds when an operating frequency enters
or exits an amateur band. This functions independent
of the confirmation beep setting (above).
The volume level can be set described below.
OONN
Band edge beep ON
(default)
OOFFFF
Band edge beep OFF
5
BBeeeepp LLeevveell
This item adjusts the volume level for (confirmation
and band edge) beep tones from 0% to 100% in 1%
steps. When beep tones are turned OFF, this setting
has no effect.
 50%
50% (default)
1
MMoonniittoorr
This item sets the TX monitor function ON and OFF.
The monitor gain can be set described below.
OONN
TX monitor function is
turned ON.
OOFFFF
TX monitor function is
turned OFF. (default)
2
MMoonniittoorr LLeevveell
This item adjusts the transmit IF signal monitor level
from 0% to 100% in 1% steps.
See p. 87 for details.
 50%
50% (default)
6
BBeeeepp LLeevveell LLiimmiitt
This item allows you to set a maximum volume level
for (confirmation and band edge) beep tones. The
beep tones are linked to the [AF] control until a spec-
ified volume level is reached—further rotation of the
[AF] control will not increase the volume of the beep
tones.
OONN
Beep level is limited with
[AF] (default)
OOFFFF
Beep level is linked to [AF]