Operation Manual

130
13
SET MODE
13
■ Miscellaneous (others) set mode (continued)
15
OOnnee TToouucchh RReeppeeaatteerr
This item turns the one touch repeater function ON
(
DDUUPP--
,
DDUUPP++
) and OFF.
When [F-2
DDUUPP
] (M-3) is pushed and held for 1 sec.,
the selected offset direction and programmed duplex
offset frequency (depending on the operating fre-
quency band) is set with the displayed frequency.
DDUUPP--
Minus offset direction is se-
lected. (default)
OOFFFF
One touch repeater function
is OFF.
14
DDUUPP OOffffsseett 443300MM
This item sets the offset (difference between transmit
and receive frequencies) for duplex operation. How-
ever, this setting is used to input the repeater offset
for the 430 MHz band. only
The offset frequency can be set from 0.000 MHz to
+9.999 MHz in 1 kHz steps.
55..000000MMHHzz
5 MHz offset (default)
13
DDUUPP OOffffsseett 114444MM
This item sets the offset (difference between transmit
and receive frequencies) for duplex operation. How-
ever, this setting is used to input the repeater offset
for an 144 MHz band only.
The offset frequency can be set from 0.000 MHz to
+9.999 MHz in 1 kHz steps.
00..660000MMHHzz
0.6 MHz offset (default)
17
TTuunneerr ((AAuuttoo SSttaarrtt))
The optional AT-180 ANTENNA TUNER has an automatic
start capability which starts tuning if the SWR is
higher than 1.5–3:1.
When “OFF” is selected, the tuner remains OFF even
when the SWR is poor (1.5–3:1). When “ON” is se-
lected, automatic tune starts even when the tuner is
turned OFF.
Even when “ON” is selected, automatic tune does
not start for the 50 MHz band.
OONN
Automatic tune function is
ON.
OOFFFF
Automatic tune function is
OFF. (default)
16
AAuuttoo RReeppeeaatteerr
This item turns the auto repeater function ON-1 (auto
duplex setting), ON-2 (auto duplex setting and acti-
vating tone encoder) or OFF.
See p. 65 for details concerning the auto repeater
function.
OONN--11
Auto duplex setting is ON.
(default)
OOFFFF
Auto repeater function is
OFF.