Operation Manual

133
13
SET MODE
■ Miscellaneous (others) set mode (continued)
30
HHMM--115511 [[FF--11]]
This item programs one of several functions to [F-1]
key of HM-151. Programmable key assignments are
described as below.
MMPPWW
Memo pad write is pro-
grammed. (default)
AANNFF
Auto notch filter is pro-
grammed.
31
HHMM--115511 [[FF--22]]
This item programs one of several functions to [F-2]
key of HM-151. Programmable key assignments are
same as above.
MMPPRR
Memo pad read is pro-
grammed. (default)
NNBB
Noise blanker function is
programmed.
34
SSSSBB//CCWW SSyynncchhrroonnoouuss TTuunniinngg
This item selects the displayed frequency shift func-
tion from ON and OFF.
When this function is activated, the received signal
will remain the same even when the operating mode
is changed between SSB and CW.
The frequency shifting value may differ according
to the CW pitch setting.
OONN
The displayed frequency
shifts when the operating
mode is changed between
SSB and CW.
OOFFFF
The displayed frequency
does not shift.
(default)
32
MMIICC UUpp//DDoowwnn SSppeeeedd
This item sets the rate at which frequencies are
scanned when the microphone (HM-151) [
YY
]/[
ZZ
]
keys are pushed and held. High or low can be se-
lected.
HHIIGGHH
High speed (default,
5 tuning steps/sec.)
LLOOWW
Low speed
(2.5 tuning steps/sec.)
33
QQuuiicckk RRIITT//∂∂TTXX CClleeaarr
This item selects the RIT/∂TX frequency clearing in-
struction for the [F-3
CCLLRR
] key.
See pgs. 73, 86 for details.
OONN
Clears the RIT/∂TX fre-
quency when [F-3
CCLLRR
] is
pushed momentarily.
OOFFFF
Clears the RIT/∂TX fre-
quency when [F-3
CCLLRR
] is
pushed and held for 1 sec.
(default)
“P.AMP/ATT” (Preamplifier/attenuator),
“NB” (Noise blanker),
“NR” (Noise reduction),
“MNF” (Manual notch filter),
“ANF” (Auto notch filter),
“TS” (Tuning step),
“SPL” (Split operation),
“A/B” (VCO A/B selection),
“MCL” (Memory clear),
“BNK” (Bank selection),
“COM” (Speech compressor),
“AGC” (AGC selection),
“TBW” (TX filter width),
“DUP” (Duplexer),
“TON” (FM tone operation),
“MET” (Meter selection),
“VSC” (Voice squelch control),
“MPW” (Memo pad write),
“MPR” (Memo pad read),
“<SCOPE>” (Scope selection),
“<METER>” (Multi-meter selection)