Operation Manual

ManualsBrandsIcom ManualsMarine RadioIC-7000

FUNCTIONS FOR RECEIVE

D Fix mode

Displays signals within the speciﬁed frequency range.

The selected band conditions can be observed at a

glance when using this mode.

q Set a mode and frequency.

w Select

(Scope).

e Push [F-3

FFIIXX

] momentarily to select the fix

mode.

•“O” and readout frequency indicator appear when the

ﬁx mode is selected.

r Push [F-4

SSPPDD

] momentarily to select the sweep

speed.

•“≈” or “≈≈” appears when Slow speed or Fast speed is

selected, respectively.

t Push [F-1

SSPPNN

] one or more times to select the

desired steps.

•±10, 25, 50, 100 and 250 kHz are available.

•Push and hold [F-1

SSPPNN

] for 1 sec. to select the ±10

kHz step.

•“

” or “

” indicates when the displayed frequency is out

of range. The scope center position can be set to the

displayed frequency by pushing and holding [F-3

FFIIXX

] for 1 sec.

•The simple band scope operates in the peak level hold

mode. Peak levels are displayed in the background of

the current spectrum in a different color until the receive

frequency changes. This can be cleared by pushing

and holding [F-2

HHLLDD

] for 1 sec., or deactivated in the

scope set mode. (p. 72)

y Push [F-2

HHLLDD

] to freeze the current spectrum dis-

play.

•“H” appears while the function is in use.

NOTE: If there is a lot of signal noise, turn the pre-

amp OFF and the attenuator ON (p. 72) to reduce

the input level and improve the readability of the

scope.

[MENU/GRP]

[F-1]

[F-2] [F-3] [F-4]

•Push and hold [MENU/GRP] for 1 sec. once or twice

to select the menu group

(Graphic).

•Push [MENU/GRP] momentarily one or more times to

select the menu

(Scope).