America Inc. Home Security System User Manual

26
4
RECEIVE AND TRANSMIT
D Speech compressor
The IC-706MKIIG has a built-in, low distortion
speech compressor circuit. This circuit increases
your average talk power in SSB mode and is espe-
cially useful for DX’ing when the receiving station is
having difficulty copying your signal.
➀ Select USB or LSB mode.
➁ Select the ALC meter.
• Push [DISPLAY] 1 or 2 times to select M, if necessary.
• Push [MENU] one or more times to select
M3, then
push [
(F-3)MET] one or more times to select “ALC.”
➂ Select the mic gain display in quick set mode.
• Push [DISPLAY] for 2 sec.
• Push [MENU] one or more times to select
Q2 MIC
GAIN
.
➃ Adjust the mic gain.
• While transmitting at your normal voice level, the ALC
meter should read at about the middle of the ALC zone.
• Be sure the mic gain is in the range of 2 to 5.
➄ Select M4.
• Push [DISPLAY] 1 or 2 times to select M, if necessary.
• Push [MENU] one or more times to select
M4.
➅ Push [(F-2)COM], then adjust [COMP GAIN] so that
the ALC meter reads within the ALC zone whether
you speak softly or loudly.
Note: When the ALC meter peaks above the ALC
zone, your transmitted voice may be distorted.
[MENU] [(F-2)COM]
[COMP GAIN]
COMP
GAIN /SIDE T
BEEP
ALC
Adjust [COMP GAIN] so that the ALC meter
reads within the ALC zone.
ALC zone
D VOX operation
The VOX (Voice-operated Transmission) function
toggles between transmit and receive with your
voice. This function provides an opportunity to input
log entries into your computer, etc., while operating.
➀ Select M4, then turn the VOX function ON.
• Push [DISPLAY] 1 or 2 times when S or G appears.
• Push [MENU] one or more times to select
M4.
• Push [
(F-1)VOX] to turn the function ON.
➁ Select VOX GAIN in quick set mode.
• Push [DISPLAY] for 2 sec. then push [MENU] one or
more times to select
Q4.
➂ While speaking into the microphone, adjust [VOX
GAIN] until the transceiver is transmitting.
➃ Select VOX DELAY in quick set mode.
• Push [MENU] one or more times to select Q3.
➄ While speaking into the microphone, adjust [VOX
DELAY] as desired.
➅ Select ANTI VOX in quick set mode.
• Push [MENU] one or more times to select Q5.
➆ If the receive audio from the speaker toggles the
transceiver to transmit during receive, adjust the
[ANTI-VOX] to the point where it has no effect.
➇ Push [DISPLAY] to exit quick set mode.
[MENU] [(F-1)VOX]
[DISPLAY]
main dial