Operation Manual

■
FFrroonntt ppaanneell
q
PPOOWWEERR SSWWIITTCCHH [[PPOOWWEERR]]
(p. 15)
Turns power ON and OFF.
•Push momentarily to turn power ON.
•Push for 2 sec. to turn power OFF.
w
AAFF GGAAIINN CCOONNTTRROOLL [[AAFF]]
(inner control; p. 15)
Rotate clockwise to increase the audio output from
the speaker; rotate counterclockwise to decrease
the audio output from the speaker.
e
RRFF GGAAIINN CCOONNTTRROOLL//SSQQUUEELLCCHH CCOONNTTRROOLL
[[RRFF//SSQQLL]]
(outer control; p. 22)
➥ Adjusts the squelch threshold level (to mute
noise when receiving no signal) in all modes.
➥ This control can be used for RF gain control to
adjust receiver gain manually.
•RF gain selection can be set in initial set mode (p. 50).
• RF gain is usable in SSB/CW/RTTY modes only.
r
FFUUNNCCTTIIOONN DDIISSPPLLAAYY
Shows the operating frequency, dot matrix indica-
tions, selected memory channel, etc. See p. 7 for
details.
t
TTUUNNIINNGG SSTTEEPP SSWWIITTCCHH [[TTSS]] ((
pgs. 17, 18)
➥ Push momentarily to cycle between 1 Hz/10 Hz,
programmable and 1 MHz tuning steps.
•1 and 10 Hz steps are only available in SSB, CW and
RTTY modes; 1 MHz steps are only available in FM,
WFM and AM modes.
➥ Push for 2 sec. to toggle between 1 and 10 Hz
steps, or; when the programmable tuning steps is
indicated, push for 2 sec. to enter programmable
tuning step mode.
y
MMOODDEE SSWWIITTCCHH [[MMOODDEE]]
(p. 19)
➥ Push momentarily to cycle through the operating
modes:
USB/LSB ➧ CW/CWå ➧ RTTY/åRTTY ➧
➧ FM/WFM/AM
➥ Push and hold for 2 sec. to toggle between the
following operating modes:
USB ↔ LSB
CW ↔ CWå
RTTY ↔ åRTTY
FM → WFM → AM → FM, etc.
u
RREECCEEIIVVEE//TTRRAANNSSMMIITT IINNDDIICCAATTOORRSS [[RRXX]]//[[TTXX]]
[RX] lights green while receiving (and squelch
opens); [TX] lights red while transmitting.
i
MMAAIINN DDIIAALL
Changes the displayed frequency, selects initial set
mode items, etc.
o
UUPP//DDOOWWNN ((BBAANNDD)) SSWWIITTCCHHEESS [[
Y
//
Z
((BBAANNDD))]]
➥ Push to select a band.
•Can also be used to advance quick set mode items,
initial set mode items, etc.
➥ Push and hold to scroll through the bands con-
tinuously.
!0
MMAAIINN DDIIAALL TTEENNSSIIOONN LLAATTCCHH
Selects the main dial tension.
•2 positions are available.
!1
MMIICCRROOPPHHOONNEE CCOONNNNEECCTTOORR
(p. 8)
Modular-type microphone connector—connects
the supplied microphone (HM-103).
•The optional OPC-589 can be used to connect an 8-pin
microphone such as the SM-8 or SM-20, if desired.
•A microphone connector is also available on the rear
1
1
PPAANNEELL DDEESSCCRRIIPPTTIIOONN
HF/VHF/UHF TRANSCEIVER
i706MK™G
AF
RIT/
SUB
MENU F-1 F-2 F-3
MODE
BAND
BAND
Y
Z
TS
DISPLAY
LOCK
RX
TX
M-CH
PHONES
TUNER/CALL
P.AMP/ATT
POWER
SHIFT
RF/SQL
q
w e
r
t
y
i
o
o
!1
!2!3!4!5!6!7!8
!9
@0
@2
@1
!0
u
CH
VFO A
P O
S1
5
53792040
10
60dB
USB
M1
SPL
A/B A=B
IC-706MKIIG.qxd 02.3.27 13:53 Page 1