Operation Manual

3
BASIC OPERATION
3-10
Setting frequency (Continued)
1/4 tuning step function D
(Mode: SSB-D/CW/RTTY)
The dial speed is reduced to
1
⁄4 of the normal speed
when the
1
⁄4 tuning function is ON, for finer tuning con-
trol.
You can set the
1
⁄4 tuning function in each operating
frequency band.
This function is selectable only when the quick tuning
function is turned OFF.
Push q
MENU
(C) one or more times to select the
“M-2” screen (M-2 menu).
Touch [1/4]( w D) to turn the
1
⁄4 tuning function ON or
OFF.
 •“ ” appears when the 1⁄4 tuning function is ON.
Auto tuning step function D
When you rapidly rotate the Dial, the tuning speed can
automatically accelerate, depending on the “MAIN DIAL
Auto TS” option in the “Function” Set mode.
Push q
SET
(C) to enter the Set mode.
Touch the “MAIN DIAL Auto TS” item of the “Func- w
tion” Set mode.
Function > MAIN DIAL Auto TS
 •Ifthespecieditemisnotdisplayed,touch[Y] or [Z](D)
one or more times to select the page.
Touch the desired option to select e the HIGH or LOW
tuning speed acceleration, or to turn OFF the func-
tion.
 •HIGH: When the tuning step is set to 1 kHz or small-
er steps, the tuning speed is approximately five
times faster.
When the tuning step is set to 5 kHz or larger
steps, the tuning speed is approximately two times
faster. (default)
 •LOW: Approximatelytwotimesfaster
 •OFF: AutotuningstepisturnedOFF.
 •Ifdesired,touchtheitemfor1secondtoopentheDefault
set window, then select the “Default” to reset to the de-
fault setting.
Push r
SET
(C) to exit the Set mode.
The L, R, C or D in the instructions indicate the
part of the controller.
L: Left side, R: Right side, C: Center bottom
D: Display (Touch screen)
Touch [1/4]
¹⁄₄ tuning icon
Touch
“Function”
Touch “MAIN
DIAL Auto TS”
Push
SET
HIGH (Default)