Operation Manual
5
D-STAR OPERATION <BASIC>
5-2
D-STAR Operating procedures
This section describes the basic D-Star procedures.
•When it is the rst time to operate D-STAR, check
whether or not you can access your local area repeat-
er (Access repeater), and if your signal is successfully
sent to a destination repeater.
•If yourcall sign (MY) hasnotbeen set, or yourcall
sign has not been registered on a D-STAR repeater,
see pages 4-2 and 4-4.
Making a Local area call D
Set “FROM” (Access repeater)1.
Push q
DR
(C) to select the DR mode.
Check whether or not “FROM” is selected. w
•If“FROM”isnotselected,touchthe“FROM”eld.
Touch the “FROM” field. e
•The“FROMSELECT”screenappears.
Touch “Repeater List.” r
•The“REPEATERGROUP”screenappears.
Touch the repeater group where your access repeat- t
er is listed.
•Example:“11:Japan”
Touch your access repeater. y
•Example:“Hirano”
•ThetransceiverreturnstotheDRmodescreen,andthe
selected repeater is set in “FROM.”
Set “TO” (Destination)2.
Check whether or not “TO” is selected. u
•If“TO”isnotselected,touchthe“TO”eld.
Touch the “TO” field. i
•The“TOSELECT”screenappears.
Touch“LocalCQ.” o
•The transceiver returns to the DR mode screen, and
“CQCQCQ”issetin“TO.”
Hold down [PTT] to transmit3.
•Whileholdingdown[PTT],theTX/RXindicatorlightsred.
See page 5-5 to check whether you can access the
repeater.
The repeater list, described in this manual, may differ from
your transceiver’s preloaded list.
Touch
“LocalCQ.”
Transmitting
Repeater area
(Sub name)
Repeater call sign
“FROM” is selected.
“Hirano” is set
on “FROM.”
Touch
“FROM.”
Touch
“Repeater List.”
Touch the re-
peater group
( Example:
“11: Japan”)
Touch your ac-
cess repeater.
( Example:
“Hirano”)
Touch
“TO.”
“TO” is selected.
“CQCQCQ” is
set on “TO.”
The L, R, C or D in the
instructions indicate the
part of the controller.
L: Left side
R: Right side
C: Center bottom
D: Display (Touch screen)
L
eft
R
ight
C
enter
D
isplay