Operation Manual
5
D-STAR OPERATION <BASIC>
5-20
Directly inputting (RPT) D
The destination repeater call sign can be directly input.
Example: Directly input the call sign “JP3YDH”
Push q
DR
(C) to select the DR mode.
Check whether or not “TO” is selected. w
•If“TO”isnotselected,touchthe“TO”eld.
Touch the “TO” field. e
•The“TOSELECT”screenappears.
Touch [ r Z] to display the next page.
Touch “Direct Input (RPT).” t
•The“DIRECTINPUT(RPT)”screenappears.
Touch the desired block one or more times to select y
the desired character or symbol.
(Example: J)
•AtoZ,0to9and/canbeselected.
•Touch “AB⇔12” to toggle between the Alphabet input
and Number input mode.
•Touch[CLR](D) to delete the selected character, symbol
or number.
•Touch“ ” to input a space.
Touch [ u f](D) to move the cursor backwards, or
touch [g](D) to move the cursor forwards.
Repeat steps i y and u to program a call sign of
up to 8 characters, including spaces, and then touch
[ENT](D).
(Example: First, J, then P, then 3, then Y, then D,
then H.)
•The transceiver returns to the DR mode screen, and
“JP3YDH” is displayed in “TO.”
•Afterprogramming,youcancorrect thecall signin the
DIRECT INPUT (RPT) screen.
•The programmedcall sign remainson the DIRECTIN-
PUT (RPT) screen, until inputting a new call sign.
The following settings are also correct.
* Although the repeater node letter is ‘B’ for 430 MHz band,
‘A’ is used in Japan. See page 5-1 for details.
If the programmed call sign is duplicated to the re-
peater list, the name is displayed. (Only when the
name has been programmed.)
The repeater node*
is input.
“/” is input.
In this case, the call sign is of
a repeater for a Gateway call.
“TO” (Destination) setting (Continued)
Program a call
sign, and touch
[ENT].
“K5TIT B” is set in “TO.”
“TO” is selected.
Touch
“TO.”
Touch
[Z].
Touch
“ Direct Input
(RPT).”
The L, R, C or D in the
instructions indicate the
part of the controller.
L: Left side
R: Right side
C: Center bottom
D: Display (Touch screen)
L
eft
R
ight
C
enter
D
isplay