Operation Manual

6
SET MODE
6-2
The Set mode is used to program infrequently changed
values or function settings.
NOTE: The Set mode is constructed in a tree struc-
ture. You may go to the next tree level, or go back a
level, depending on the selected item.
The Set mode settings D
Push q
SET
(C) to enter the Set mode.
If the specified item is not displayed, touch [ w ∫] or [√]
(D) one or more times to select the page.
 •If[∫](D) or [√](D) is continuously held down, the pages
are quickly scrolled.
 •RotatingtheDialalsoselectsthepages.
Touch a desired item to go to the next level. e
Repeat steps r w and e to show the desired item’s
setting screen.
 •To go back the previous tree level, touch [](D), or
MENU
(C).
Touch a desired option shown on the display, or [+]/ t
[–](D) to adjust a level.
 •Whenyoutouchanoption,itisautomaticallysavedand
the screen returns to the previous display.
 •RotatingtheDialalsoadjuststhelevel.
 •Push
QUICK
(C), and then touch “Default” to reset to the
default setting, if desired.
 •Tosetotheritem,touch[](D), or
MENU
(C) to go back
a tree level.
Push y
SET
(C) to exit the Set mode.
Set mode description
The L, R, C or D in the
instructions indicate the
part of the controller.
L: Left side
R: Right side
C: Center bottom
D: Display (Touch screen)
L
eft
R
ight
C
enter
D
isplay
SET
Example: Change the “Memopad Numbers” item option
to “10.”