Operation Manual

12
SET MODE
12-4
Function
Beep Level (Default: 50%)
Sets the beep output level.
• Range: 0 ~ 100%
L If the “Beep (Conrmation)” item is set to “OFF,” no
beep sounds.
Beep Level Limit (Default: ON)
Selects whether or not to limit the volume up to the
specied level.
• OFF: Does not limit the volume level.
• ON: Limits the volume level.
Further rotation of
AF RF/SQL
(inner) does not
increase the level.
Beep (Conrmation) (Default: ON)
Turns the Conrmation beep ON or OFF.
• OFF: Does not sound the beep.
• ON: Sounds the beep when a key is pushed.
• If the “Beep Level” item is set to “0%,” no beep sounds.
Band Edge Beep (Default: ON (Default))
Turns the Band Edge beep ON or OFF.
• OFF:
Does not sound the Band Edge beep.
• ON(Default):
The Band Edge beep sounds on the band edge.
• ON(User):
The beep, which is selected in the User Band Edge
screen, sounds. (p. 3-7)
• ON(User) & TX Limit:
The beep, which is selected in the User Band Edge
screen, sounds.
Transmit is limited to the range between the upper
and lower band edges. (p. 3-7)
InformationL
• If the “Beep Level” item is set to “0%,” no beep sounds.
• When you tune into an amateur band’s frequency
range, the Band Edge high beep sounds.
• When you tune out of an amateur band’s frequency
range, the Band Edge low beep sounds.
RF/SQL Control (Default: RF+SQL)
Set the
AF RF/SQL
(outer) control operation.
• Auto: While in the AM or FM mode, operates as
only a squelch control.
While in the SSB, CW or RTTY mode,
operates as only an RF gain control.
• SQL: Operates as only a squelch control.
LRF gain is xed at maximum sensitivity.
• RF+SQL: Operates as an RF gain control, and a
noise squelch* or S-meter squelch.
*Only in the FM mode.
When using as an RF gain/squelch control
When using as an RF gain control
(Squelch is xed open: SSB, CW, RTTY only)
When using as a squelch control
(RF gain is xed at maximum.)
MF Band ATT (Default: ON)
Turns the MF Band Attenuator function ON or OFF.
This function adds approximately 16 dB of attenuation
to prevent a desired signal from becoming distorted
when very strong MF band signals are received.
This function is usable when the frequency is set
to between 0.03000 and 1.59999 MHz, for only
receiving.
L When you receive a weak signal on the MF band,
select “OFF.”
L The 16 dB of the MF band attenuation is added to
any other attenuation value that you have set.
Noise squelch (FM mode)
S-meter squelch
adjustable range
Maximum
RF gain
Maximum
S-meter squelch
Minimum
RF gain
RF gain
adjustable range
Squelch is open
is displayed
Maximum
RF gain range
Minimum
RF gain
RF gain
adjustable range
is displayed
Maximum RF gain
Noise squelch (FM mode)
S-meter squelch
threshold
S-meter squelch
adjustable range
Maximum
S-meter squelch
Squelch is open
Noise squelch
threshold