User Guide

11
80
SET MODE
2001 NEW
2. LCD Backlight
This item adjusts the brightness of the LCD from 0%
to 100% in 1% steps.
(default: 50%)
LCD Backlight
5O%
2
■ General set mode
DD
Entering set mode
Set mode is used for programming infrequently
changed values or conditions of functions.
• Set mode operation
q Push [MENU] several times to select the function
menu indication, if necessary.
w Push [MENU] for 1 sec. to enter the set mode.
e Push [F1 ≤] or [F2 ≥] to select the desired item.
r Set the desired condition using the tuning dial.
•Push [F3] for 1 sec. to select a default condition or value.
t Push [MENU] to exit the set mode.
DD
Set mode items
1. LCD Contrast
This item adjusts the contrast of the LCD from 0% to
100% in 1% steps.
(default: 50%)
LCD Contrast
5O%
1
3. Beep Level
This item adjusts the volume level for confirmation
beep tones from 0% to 100% in 1% steps. When the
beep tones, item 6. Beep (p. 81), are turned OFF,
this setting has no effect.
(default: 50%)
Beep Level
3
5O%
4. Beep Level-lmt
This item allows you to set a maximum volume level
for confirmation beep tones. Confirmation beep tones
are linked to the [AF] control until a specified volume
level is reached— further rotation of the [AF] control
will not increase the volume of the beep tones.
ON Confirmation beep ON (default)
OFF Confirmation beep OFF
Beep Level-lmt
4
ON
[F1 ≤]
Tuning dial[MENU]
[F2 ≥]
5. CAL. Marker
This item is used for a simple frequency check of the
transceiver.
ON Calibration marker ON
OFF Calibration marker OFF (default)
See p. 93 for calibration procedure.
Turn the calibration marker OFF after checking the
frequency of the transceiver.
Cal. Marker
5
OFF
IC-7400.qxd 02.4.2 11:35 Page 80