Operation Manual

• Offset frequency setting
Command : 1A 05 0065, 0066, 0072
1 kHz digit: 0–9 100 Hz digit: 0 (fixed) 100 kHz digit: 0–9 10 kHz digit: 0–9 10 MHz digit: 0–9
†
1 MHz digit: 0–9 Direction: 00=+ direction 01=– direction
q
0X X X X XX
w e
0
r*
*No need to enter for transverter offset frequency setting.
†
Transverter offset only; Fix to ‘0’ for split offset setting.
• Codes for memory name, opening
message and CLOCK2 name contents
To send or read the desired memory name settings,
the character codes, instructed codes for memory
keyer contents, and follows are used.
• Character’s code— Alphabetical characters
Character ASCII code Character ASCII code
a–z 61–7A — —
• Character’s code— Symbols
Character ASCII code Character ASCII code
! 21 # 23
$ 24 % 25
& 26 ¥ 5C
? 3F ” 22
’ 27 ` 60
+ 2B – 2D
: 3A ; 3B
= 3D < 3C
> 3E ( 28
) 29 [ 5B
] 5D { 7B
} 7D | 7C
_ 5F – 7E
@ 40
Command Set item/Available characters
1A00
Memory name
All char
acters are available.
1A05 0052
Open
ing message
Capital letters, numerals, some symbols (− /
. @) and space are available.
1A05 0057
CLOCK 2 name
C
apital letters, small letters, numerals,
some symbols (! # $ % & ¥ ? " ’ ` ^ + – ✱ /
. , : ; = < > ( ) [ ] { } ¦ _
–
@) and space are
a
vailable.
• Color setting
Command : 1A 05 0106, 0107, 0140, 0149, 0150,
0151, 0152, 0154, 0159, 0160,
0161, 0162
q
0 X X X 0 X X X 0 X X X
w e r t y
R (Red)
0000–0255
G (Green)
0000–0255
B (Blue)
0000–0255
• Bandscope edge frequency setting
Command : 1A 05 0115, 0116, 0117, 0118, 0119,
0120, 0121, 0122, 0123, 0124,
0125, 0126
1 kHz: 0–9 100 Hz: 0 (fixed) 100 kHz: 0–9 10 kHz: 0–9 10 MHz: 0–6 1 MHz: 0–9 1 kHz: 0–9 100 Hz: 0 (fixed) 100 kHz: 0–9 10 kHz: 0–9 10 MHz: 0–6 1 MHz: 0–9
q
X X X X X X X X X X X X
w e r t y
Lower edge Higher edge
• Data mode with filter width setting
Command : 1A 06
q
X X X X
w
00=Data mode OFF
01=FIL1
02=FIL2
03=FIL3
00=Data mode OFF
01=Data mode 1 (D1)
02=Data mode 2 (D2)
03=Data mode 3 (D3)
158
12
CONTROL COMMAND
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21