User Guide

7
3
SCAN OPERATION
■ On–hook scan
On–hook scan (Hanger scan) is available when taking the mi-
crophone from its hanger (off–hook) and /or returning it into
the hanger (on–hook).
q Push [SCAN] to start scanning.
w When receiving a signal, scan pauses until the signal dis-
appears.
➥ You can converse by taking the microphone from the hook.
e Place the microphone on the hook to restart scanning.
r Scan restarts 2 sec. after the signal disappears even if you
did not converse the station.
When you take the microphone during the scan operation.
➥ In VFO scan; scan resumes promptly to frequency.
➥ In memory scan; scan resumes promptly to memory chan-
nel.
➥ In priority memory scan; scan resumes to priority channel,
NOTE: Be sure to connect the supplied microphone
hanger to the vehicle’s ground for on/off hook microphone
functions. (p. 12)
■ Dualwatch
Dualwatch monitors priority channel while you are receiving
an other channel (VFO or memory channel).
•If a signal is received on
priority channel, dual-
watch pauses on priority
channel until the signal
disappears.
•To transmit on the se-
lected channel during du-
alwatch, push and hold
PTT.
ïï
Operation
q Select the desired operating channel (VFO or Memory
channel).
w Push and hold [PRI] for 1 sec. to start dualwatch.
‘P’ blinks during dualwatch.
e To cancel dualwatch, push [PRI] again.
VFO
frequency
or
memory
channel
Priority
channel
5 sec.
250 msec.
IC-A110EURO-2 02.3.12 2:00 PM Page j (1,1)