User Guide

9
4
MEMORY PROGRAMMING
■ Memory names
ï Programming memory names
q Select the memory channel to be programmed:
➥ Push [V/M] to select memory mode.
➥ Turns [DIAL] to select the memory channel.
w Push [V/M] for 5 sec. to enter memory name writing mode.
• The first character of the name flashes.
e Turns the [DIAL] as many times as necessary to enter the
desired name.
• To erase a character, overwrite with a space (displayed as _).
• To move the cursor forwards or backwards, use [Y] or [Z].
• Push [SQL]
for 2 sec. to erase all characters.
r Push [SCAN/MW] for 2 sec. to input the set name.
• Flashing stops.
• Memory channels can be programmed with names of up to 7
characters in length.
• When no name is programmed, the display shows the operating
frequency.
NOTE: Push PTT switch to abort the programming memory
name.
• The following characters can be used in names:
➥
0 to 9, A to Z (capitals), (space), $, %, ’, (, ), ✽, +, “ ,
”, –, /, <, =, >, ?, @, [, \, ], ^, _ and `.
V/M
for 5 sec.
V/M
for 1 sec.
+
or
[EXAMPLE]: Setting the name to “ TOWER 2”
IC-A110EURO-2 02.3.12 2:00 PM Page l (1,1)