User Guide

15
3
BASIC OPERATION
DD
DTCS code setting
This transceiver is equipped with 84 DTCS codes and OFF.
DTCS operation provides communication with silent standby since
you will only receive calls from group members using the same
DTCS code.
q Turn power OFF in advance.
w While pushing and holding [PTT], [Upper] and [Lower], rotate
[VOL] to turn the power ON.
e Rotate [CH selector] to select the desired channel (1 to 15) that
you want to assign the DTCS code to.
r Push and hold [Lower] until a long beep is emitted.
t Push [PTT] the necessary number of times to choose the 10
digit of the desired DTCS code number (grey column) from the
list at right.
y Push [Upper].
• Confirmation beep(s) is (are) emitted. (See the Confirmation beep
list on p. 14.)
u Push [PTT] the necessary number of times to choose the 1 digit
of the desired DTCS code number (grey column) from the list at
right.
i Push [Upper].
• Confirmation beep(s) is (are) emitted. (See the Confirmation beep
list on p. 14.)
o If you want to use Inverse mode, push [PTT] once more.
*You can skip this step, if you want to use Normal mode.
!0 Push [Upper] to complete the setting.
• A short beep is emitted.
!1 Turn power OFF, then ON again.
[Example]: Code No. 16 (114) with Inverse mode assignment to
channel 5
q Turn power OFF in advance.
w While pushing and holding [PTT], [Upper] and [Lower], rotate
[VOL] to turn the power ON.
!IC-F25SR-0.qxd 06.10.5 6:31 PM Page 15 (1,1)