User Guide

17
3
BASIC OPERATION
‘‘
Find scan operation
This transceiver can detect the CTCSS tone and DTCS code* in
the received signal. By monitoring a signal that is being transmit-
ted from the other station, you can determine the tone frequency or
DTCS code* required to communicate with them.
This function is very useful when you are going to communicate
with unknown CTCSS tone or DTCS code* stations.
Scans all of the CTCSS tone and DTCS code*, then stops when a
matched tone or code* is detected.
q Turn power OFF in advance.
w While pushing and holding [Upper] and [Lower], rotate [VOL] to
turn power ON.
Do not select channel 16 before turning power ON.
e Rotate [CH selector] to select the desired channel (1 to 15) that
you want to assign the CTCSS tone or DTCS code* to.
r Push and hold [Upper] for 1 sec. to start scan.
• The LED indicator blinks green slowly.
• Push [Upper] to stop the scan.
t The scan pauses when the matched tone or code* is detected.
• Push [Upper] to determine the detected tone or code* number, and
stop the scan.
• Scan resumes 3 sec. after the signal disappears.
y Turn power OFF, then ON again.
Even if the scan is stopped with pushing [Upper], scan resumes
after pushing and holding [Upper].
* Depends on the pre-setting.
!IC-F25SR-0.qxd 06.10.5 6:31 PM Page 17 (1,1)