Operation Manual

4
SETTINGS
8
Setting the beep and announcement level
[Rotary Selector]
[VOL]
[Lower]
[Upper]
2
5
4
3
1
5 (Linked)
4 (Linked)
3 (Linked)
2 (Linked)
1 (Linked)
Pushing
[Upper]
Youcanadjustthebeepandannouncementlevel
between1and5,or1(linked)and5(linked).When
alinkedoptionisselected,thebeepaudiolevelis
adjustablebyrotating[VOL].
1) Rotate [VOL] to turn OFF the transceiver.
2) Set [Rotary Selector] to any channel other than
Channel 16.
3) While holding down [Lower], rotate [VOL] to turn
ON the power and enter the Beep Level Adjustment
mode.
 •Anopeningbeepsoundsandtheselectedchannel
numberwillbeannounced.
4) Push[Upper]tochangethebeeplevel.
 •Abeepsoundseverytimeyoupush[Upper].
5) Rotate [VOL] to turn OFF the power and exit the
Beep Level Adjustment mode.
NOTE:
•Repeatedlypushing[Upper]rstselects1(lowest)
to5(highest),andthenselectsthelowestlinked
level,1(Linked)tothehighest,5(Linked).
Repeatedly pushing [Upper] repeats the cycle. See
the illustration to the right.
•Theadjustablerangeis1to5or1(Linked)to5
(Linked).
•Abeepsoundseverytimeyoupush[Upper].
 Therefore,youcandeterminethecurrentlevel
settingbytheincreasingloudnessofthebeepthat
sounds.
•Todetermineifyouhaveselectedalinkedlevel,set
[VOL] to minimum, then push [Upper] repeatedly,
listeningfortheloudestbeep(level5).Pushing
[Upper]onceaftertheloudestbeepwillselect1
(Linked).Repeatedlypush[Upper]toselectthe
desired linked level.
NOTE:
TurnONtheBeepfunction(p.7)beforeyoustart
settingthebeepandannouncementlevel.