Operation Manual

4
SETTINGS
10
Setting the ringer level
[Rotary Selector]
[VOL]
[Lower]
[Upper]
2
5
4
3
1
5 (Linked)
4 (Linked)
3 (Linked)
2 (Linked)
1 (Linked)
Pushing
[Lower]
Pushing
[Upper]
Youcanadjusttheringerlevelbetween1and5,
or1(Linked)and5(Linked).Whenalinkedoption
isselected,theringeraudiolevelisadjustableby
rotating [VOL].
1) Rotate [VOL] to turn OFF the transceiver power.
2) Set [Rotary Selector] to Channel 16.
3) While holding down [Lower], rotate [VOL] to
turn ON the power and enter the Ringer Level
Adjustment mode.
 •Anopeningbeepsoundsand “Sixteen” willbe
announced.
4) Push [Upper] to increase, or push [Lower] to
decrease the ringer level.
 •Abeepsoundsafterpushing[Upper]or[Lower].
5) Rotate [VOL] to turn OFF the power and exit the
Ringer Level Adjustment mode.
NOTE:
•Repeatedlypushing[Upper]rstselects1(lowest)
to5(highest),andthenselectsthelowestlinked
level,1(Linked)tothehighest,5(Linked).
Repeatedly pushing [Upper] or [Lower] repeats the
cycle. See the illustration to the right.
•Theadjustablerangeis1to5or1(Linked)to5
(Linked).
•Abeepsoundsafterpushing[Upper]or[Lower].
Therefore,youcandeterminethecurrentlevel
settingbytheincreasingordecreasingloudnessof
thebeepthatsounds.
•Todetermineifyouhaveselectedalinkedlevel,
set [VOL] to minimum, then push [Upper] up to
10times,listeningfortheloudestbeep(level5).
Pushing[Upper]onceaftertheloudestbeepwill
select1(Linked).Repeatedlypush[Upper]or
[Lower] to select the desired linked level.
NOTE:
TurnONtheBeepfunction(p.7)beforeyoustart
setting the ringer level.