Operation Manual

4
SETTINGS
12
Setting the squelch level
[Rotary Selector]
[VOL]
[Lower]
[Upper]
Youcanadjustthesquelchlevel.Thesquelchcircuit
mutes the received audio signal, depending on the
signal strength.
1) Rotate [VOL] to turn OFF the transceiver power.
2) Set [Rotary Selector] to any channel other than
Channel 16.
3) While holding down [Upper], rotate [VOL] to
turn ON the power and enter the Squelch Level
Adjustment mode.
 •Anopeningbeepsoundsandtheselectedchannel
numberwillbeannounced.
4) Push[Upper]toincreasethesquelchlevel(tight
squelch), or push [Lower] to decrease the squelch
level(loosesquelch).
 •Abeepsoundsafterpushing[Upper]or[Lower].
5) Rotate [VOL] to turn OFF the power and exit the
Squelch Level Adjustment mode.
NOTE:
•Theadjustablerangeis0(loosesquelch)to9(tight
squelch).
•Abeepsoundsafterpushing[Upper]or[Lower].
Anerrorbeepsoundsifyoutrytoexceedthe
adjustablerange.
NOTE:
TurnONtheBeepfunction(p.7)beforeyoustart
setting the squelch level.