Operation Manual

5
Section 3
LED INDICATOR
The LED indicator indicates the status of various
parameters of the transceiver as follows:
(Reference: R is Red, G is Green, O is Orange)
About the LED indicator
•Cloning:
Blinks while reading or writing data.
•CloningError:
Blinks if cloning fails.
•ChannelError:
Blinks when you select a blank channel, or an
unlocked channel.
•TXlowBattery1:
 BlinkswhiledetectingalowbatteryintheTXmode.
•TXlowBattery2:
 BlinkswhiledetectingaverylowbatteryintheTX
mode.
•TX:
Lights red while transmitting.
•RXbusy:
On an analog channel, lights green when in the
noise squelch opens.
On a digital channel, lights green while detecting a
frame synchronization.
•Scan:
Blinks while scanning for a channel to search for a
signal.
•LowBattery1:
Blinks slowly when you should charge the battery
soon.
•LowBattery2:
Blinks fast when you must charge the battery.
•PowerON:
Blinks at transceiver startup.
•CHAccess:
Blinks while making a Smart-Ring call.
•TXError:
 Blinkswheninhibitingtransmission(Lockout,TX
Inh, or TOT).
G GGG G GGG
R G R G R G R G R G R G R G R G
R O R O R O R O R O R O R O R O
R R
R R R R
R
G
G G
G G
G G G G
R O G R O G
OOOOOO
OOOR