Operation Manual

7
Section 4
SETTINGS
Setting the Beep function
You can turn the Beep function ON or OFF.
1) Rotate [VOL] to turn OFF the transceiver power.
2) Set [Rotary Selector] to any channel other than
Channel 16.
3) While holding down [Lower], rotate [VOL] to turn
ON the power to enter the Beep Level Adjustment
mode.
 •Anopeningbeepsoundsandtheselectedchannel
numberwillbeannounced.
4) Push [Lower] to turn the Beep function ON or OFF.
 •Whenabeepsoundsafterpushing[Lower],theBeep
function is ON.
 •Whennobeepsoundsafterpushing[Lower],theBeep
function is OFF.
5) Rotate [VOL] to turn OFF the power and exit the
Beep Level Adjustment mode.
[Rotary Selector]
[VOL]
[Lower]
[Upper]
NOTE:
•Thetransceiverstoresthesettingeverytimeyou
change it.
•Ifdesired,push[Upper]toadjustthebeeplevel.
See page 8 for details.
NOTE:
TurnONtheBeepfunctionwhenyousetthebeep
and announcement level, Call-Ring ringer, ringer
level, microphone gain, squelch level, VOX function,
orVOXgaintocheckthecurrentlevelsettingby
countingorhearingbeeps.(pp.8–14)