Operation Manual

2
PANEL DESCRIPTION
DTMF AUTODIAL KEY “DTMA”
Push to enter the DTMF channel selection mode. Then select
the desired DTMF channel using [CH Up]/[CH Down]. After
selecting the DTMF channel, push again to transmit the
selected DTMF code.
RE-DIAL KEY “DTMR”
Push to transmit the last-transmitted DTMF code.
CALL KEYS “CALL” “CALA” “CALB”
Push to transmit a 2/5-tone or BIIS ID code.
•Call transmissionisnecessary before you call another station
depending on your signaling system.
•[CallA]and/or[CallB]maybeavailablewhenyoursystememploys
selective‘Individual/Group’calls.Ask yourdealer whichcall is
assigned to each key.
EMERGENCY KEY “EMR”
Push and hold to transmit the emergency call.
•Theemergencycalltransmitswithbeeps;thedisplaydoesnot
change.
•Thetransceivercantransmittheemergencycallsilentlyorwiththe
display changes depending on the pre-setting. Ask your dealer for
details.
•Ifyouwanttocanceltheemergencycall,pushandholdthekey
again before transmitting the call.
•Theemergencycallistransmittedonetimeonlyorrepeatedlyuntil
receiving a control code, depending on the pre-setting.
SURVEILLANCE KEY “SURV”
Push to turn the surveillance function ON or OFF.
When this function is turned ON, the beep is not emitted and
the LCD backlight does not light when a signal is received or
a key is pushed, etc.
TX CODE ENTER KEYS “TXCE”
Push to enter the ID code edit mode directly, for both 5-
tone and MSK. Then set the desired digit using [CH Up]/[CH
Down]. (p. 15)
TX CODE CHANNEL SELECT KEY “TXC”
Push to enter the TX code channel selection mode. Then set
the desired channel using [CH Up]/[CH Down]. (pp. 14, 15)
TX CODE CHANNEL UP/DOWN KEYS “TXCU” “TXCD”
Push to select a TX code channel directly.
ID-MEMORY SELECT KEY “IDMS”
➥ Recalls detected ID codes.
 •Push this key, then select the ID code using [CH Up]/[CH
Down].
 •Upto5ID’sarememorized.
➥Pushandholdfor1sec.toerasetheselectedID’s.
SCRAMBLER KEY “SCR”
Push to toggle the voice scrambler function ON and OFF.
9