Operation Manual

■ Turning power ON
Prior to using the transceiver for the first time, the battery
pack must be fully charged for optimum life and operation.
(p. 19)
q Rotate [VOL] to turn the power ON.
w If the transceiver is programmed for a start up password,
input the digit codes as directed by your dealer.
 •10-keypadcanbeusedforpasswordinputdependingon
version.
 •Thekeysinthetablebelowcanbeusedforpasswordinput.
 •Thetransceiverdetectsnumbersinthesameblockasidentical.
Therefore “01234” and “56789” are the same.
KEY
NUMBER
0
5
4
9
3
8
2
7
1
6
(Side1)
P0
P1
P2
P3
e When the “PASSWORD” indication does not clear after
inputting 6 digits, the input code number may be incorrect.
Turn the power off and start over in this case.
■ Channel selection
Several types of channel selections are available. Methods
may differ according to your system set up.
NON-ZONE TYPE:
To select the desired operating channel:
•Push[CHUp]or[CHDown].
•Rotate[ROTARYSELECTOR]*.
- Up to pre-programmed 16 channels can be selected.
•Pushoneof[MR-CH1]to[MR-CH4].
ZONE TYPE:
To select the desired zone:
•Push[Zone],thenpush[CHUp]or[CHDown].
•Push[ZoneUp]or[ZoneDown].
•Rotate[ROTARYSELECTOR]*.
- Up to pre-programmed 16 zones can be selected.
D Voting operation
The transceiver automatically starts scanning when a zone,
specified for the voting operation, is selected.
The voting scan detects the S-meter of the repeater and
automatically selects the strongest station.
3
BASIC OPERATION
11