Operation Manual

8
2
PANEL DESCRIPTION
MEMORY CH 1/2/3/4 KEYS CH1” “CH2CH3” “CH4
Push to directly select memory channels 1 to 4.
MONI KEY MON
Push to mute and release the CTCSS (DTCS) or 2-tone
squelch mute. Open any squelch or deactivate any mute
while holding down this key. (LMR operation only)
Independently activates one or two of the following func-
tions on each channel. (PMR operation only)
Hold down to unmute the channel (audio is heard; ‘Audible
mode).
• Push to mute the channel (sets to ‘Inaudible’ only).
Push after the communication is nished to send a ‘reset code’.
(5-tone/BIIS operation only)
NOTE: The unmute mode (‘Audible’ mode) may auto-
matically return to the mute mode (‘Inaudible‘ mode)
after a specified period.
LIGHT KEY LIGT
Push to temporarily turn ON the transceiver’s backlight, only
when the backlight function is turned OFF in the User set mode.
LOCK KEY LOCK
Hold down for 1 second to electronically lock all program-
mable keys to prevent accidental frequency changes and
unnecessary function access, except the following:
[PTT], [Call] (incl. Call A and Call B), [Moni(Audi)],
[Light], [Emergency], [Surveillance], [Lone Worker] and
[OPT 1/2/3].
Hold down for 1 second again to turn the lock function OFF.
LONE WORKER KEY LONE
Push to turn the Lone Worker function ON or OFF.
If the Lone Worker function is activated, the Emergency function is
automatically turned ON after the specified time period has passed
with no operation performed.
HIGH/LOW KEY H/L
Push to select the transmit output power temporarily or per-
manently, depending on the presetting.
Ask your dealer for the output power level for each selection.
TONE/RAN CH SELECT KEY T SEL
While in the analog mode, push to enter the continuous
tone channel selection mode. Then select the desired tone
frequency/code setting using [CH Up] or [CH Down]. After
the selection, push this key again to set the tone/code.
While in the digital mode, push to enter the RAN channel
selection mode. Then select the desired RAN setting using
[CH Up] or [CH Down]. After the selection, push this key
again to set the RAN.
While in the mixed (digital and analog) mode, push to enter
the continuous tone channel selection mode. Then select
the desired tone frequency/code setting using [CH Up] or
[CH Down]. After the selection, push this key to set the
tone/code. After that, the RAN channel selection screen
appears. Select the desired RAN setting using [CH Up] or
[CH Down]. After the selection, push this key again to set
the RAN.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16