Operation Manual

Optional HM-184 ■

Tu rn OFF the trans-

ceiver power when at-

taching or detaching

the microphone.

Speaker

Belt clip

Microphone

PTT SWITCH

Hold down to

transmit;

release to receive.

NEVER immerse the connector in water. If the connector

becomes wet, be sure to dry it BEFORE attaching it to the

transceiver.

NOTE: The microphone element is located at the top of

the speaker microphone, as shown in the diagram above.

To maximize the readability of your transmitted signal

(voice), hold the microphone Approximately 5 to 10 cm (2

to 4 inches) from your mouth, and speak at a normal voice

level.

To attach ■

Attach the connector of the speaker microphone into the multi

connector on the transceiver and tighten the screw.

CAUTION: Firmly attach

to the multi connector, but

do not overtighten.

A loose connection will al-

low water intrusion into

the connector; an over-

tightened connection will

damage the connector

pins in the transceiver.

Coin

Screw

IMPORTANT: KEEP the connector cover attached to the

transceiver when the speaker microphone is not in use.

(p. 3)

Water will not get into the transceiver, even if the cover is

not attached. However, the terminals (pins) will become

rusty, or the transceiver will function abnormally if the con-

nector becomes wet.

SPEAKER MICROPHONE