Operation Manual

BATTERY CASE

BP-261 optional battery case ■

Alkaline batteries installation D

Install six AA (LR6) size alkaline batteries as described

below.

Unhook the battery cover release hook ( q q), and open the

cover in the direction of the arrow (w). (Fig.1)

Install six AA (LR6) size alkaline batteries. (Fig.2) w

• Install only alkaline batteries.

• Be sure to observe the correct polarity.

Replace the cover in the direction of the arrow ( e e), then

close (r). Push the battery cover release hook until it

makes a ‘click’ sound (t). (Fig.3)

CAUTION:

• When installing the batteries, make sure they are all the

same brand, type and capacity. Also, do not mix new and

old batteries together.

• Keep battery terminals clean. It’s a good idea to occa-

sionally clean them.

• Never incinerate used battery cells since internal battery

gas may cause them to rupture.

•

Never expose a detached battery case to water. If the bat-

tery case gets wet, be sure to wipe it dry before using it.

NOTE: When the optional battery case is attached, the

battery type must be set to “DRY BATT” when turning ON

the transceiver. (p. 11)

BP-261

Fig.1

Fig.2

Fig.3