User's Manual

MAINTENANCE
24
9
CLONING
23
8
‘‘
Optional UT-96/ UT-105/ UT-108/ UT-109/
UT-110 and UT-111 installation
You can install one of the following optional signaling units in the
transceiver. UT-96
2TONE/5TONE
UNIT, UT-105 SmarTrunk
(TM)
Logic
Board, UT-108
DTMF DECODER UNIT, UT-109/ UT-110 SCRAM-
BLER UNIT
or UT-111
TRUNKING BOARD.
q Take off the optional connecter access cover (named 2251 OPT
sheet).
•
Insert a screwdriver into the
hollow of the chassis, then lift
and take away the cover. (The
cover can not be used again.)
w Attach the desired optional unit. Insert the connector tightly to
avoid bad contact.
e Remove the paper backing of 2251 OPT sheet supplied as ac-
cessory.
r Attach the new 2251 OPT
sheet to the service window.
t Program the necessary infor-
mation with the cloning soft-
ware before operation. Please
ask your dealer or system op-
erator for details.
w
e
r
q
‘‘
Cloning
Cloning allows you to quickly and easily transfer the programmed
contents from one transceiver to another transceiver; or data from
PC to a transceiver using the optional CS-F3G
CLONING SOFT-
WARE.
DD
Transceiver-to-transceiver cloning
q Connect the optional OPC-474 CLONING CABLE with adapter
plugs to the [SP] jack of the master and slave transceivers.
• The master transceiver is used to send data to the slave trans-
ceiver.
w While pushing [P0] and [
YY
], turn the transceiver’s power on to
enter cloning mode (For both the master transceiver and slave
transceiver).
•
“CLONE” appears and the transceiver enters the clone standby
condition.
e Push [PTT] on the master transceiver.
•
“CLOUT” appears in the master transceiver’s display.
•
“CL IN” appears automatically in the slave transceiver’s display.
•
When cloning is finished, “CLONE” appears in the master trans-
ceiver’s display.
NOTE: DO NOT push the [PTT] on the slave transceiver during
cloning. This will cause a cloning error.
r When cloning is finished, turn power off, then on again to return
to normal operation.
DD
PC-to-transceiver cloning
Please refer to the HELP file that comes with the CS-F3G
CLONING SOFTWARE.
CAUTION: Imprudent cloning operation causes a cloning error.
In such a case, memory contents may be lost. Cloning must then
be repeated.
IC-F3GT-(2) 00.1.11 4:12 PM Page 26 (1,1)