Operation Manual

6
MENU SCREEN
6-10
Acquisition
In the Digital mode (dPMR™ Trunking only)
Selects a Control CH Acquisition Parameter to use� The
Acquisition Parameter determines whether a site is out
of the service range or not� (p� 7-14)
TIP: You can set the Control CH Acquisition
Parameter using the programming software� See the
programming softwareʼs Help le for details.
Call Back
In the Digital mode (dPMR™ Trunking only)
Turns the Call Back function ON or OFF�
The Call Back function automatically sends back an
acknowledgement (Call Back) to the caller station
after receiving an Individual call� (p� 7-20)
Retention
In the Digital mode (dPMR™ Trunking only)
Selects a number for the Control CH Retention
Parameter� The Retention Parameter determines
whether a site is within the service range or not�
(p� 7-15)
TIP: You can set the Control CH Retention
Parameter using the programming software� See the
programming softwareʼs Help le for details.
Roaming Request
In the Digital mode (dPMR™ Trunking only)
Turns the Roaming Request function ON or OFF�
When this function is turned ON, the transceiver starts
a Roaming Scan, regardless of the error rate� (p� 7-16)
L If the Site Lock function is turned ON, the transceiver
resumes a Roaming Scan when this function is turned
ON�
Site Select
In the Digital mode (dPMR™ Trunking only)
Displays the “Site Select” screen� Then, push
[P2 (Up)] or [P1 (Down)] to select a site� After
selecting, push [OK] to save� (p� 7-18)
Site Lock
In the Digital mode (dPMR™ Trunking only)
Turns the Site Lock function ON or OFF� When
this function is turned ON, the transceiver cancels
resuming a Roaming Scan, and stays on the current
site, regardless of the error rate� (p� 7-17)
Lone Worker
Turns the Lone Worker function ON or OFF�
When this function is ON, the transceiver
automatically enters the Emergency mode if no
operation occurs during the preset period of time�
Surveillance
Turns the Surveillance function ON or OFF�
When this function is ON, beeps are not heard and
the backlight and the Status indicator do not light,
even when a signal is received, or a key is pushed�
VOX
Turns the VOX function ON or OFF�
When this function is ON, the receive and transmit are
automatically switched by detecting the user’s voice�
NOTE: To use the function, a headset* and a VOX
converter cable are required (purchase separately)�
* A Bluetooth headset is also usable�
VOX Delay
Sets the VOX Delay�
The VOX Delay is the period of time the transceiver
continues transmitting after the user stops speaking,
and then the VOX switches to receive�
• Range: 0�5 ~ 3�0 seconds
NOTE: If you set the time too short, a pause in
a conversation may be regarded as the end of
conversation, and the transceiver will start receiving,
even as the conversation continues�
VOX Gain
Sets the VOX gain�
The VOX function automatically switches between
receive and transmit by detecting the user’s voice�
• Range: 1 ~ 10
L Higher values make the VOX function more
sensitive to sounds�
Trunking Functions
Previous view