Operation Manual

7
dPMR™ OPERATION
7-4
D Transmitting a Talkgroup call
You can call a specic Talkgroup station�
(Menu > Signaling/Call > Call List Select)
1� Push [Menu] to display the Menu screen�
2� Push [P2 (Up)] or [P1 (Down)] to select “Signaling/
Call,” then push [OK]�
Channel/Scan ►
Signaling/Call ►
Menu
3� Push [P2 (Up)] or [P1 (Down)] to select “Call List
Select,” then push [OK]�
Call List Select ►
Call Menu ►
Signaling/Call
4� Push [P2 (Up)] or [P1 (Down)] to select a
Talkgroup ID�
✔ Station 1
✔ Group 1
Call List Select
5� Push [PTT] to transmit a Talkgroup call�
6� Hold down [PTT] to speak�
7� Release [PTT] to receive�
8� After the communication is nished, push [Back].
• The transceiver sends a Disconnect signal to
terminate the call�
L Either station can send a Disconnect signal�
TIP:
• You can also select a Talkgroup in the “Group
Select” screen�
(Menu > Signaling/Call > Group Select)
• You can also transmit a Talkgroup call through the
Call Menu�
(Menu > Signaling/Call > Call menu)
• When a Talkgroup ID is set in the Memory CH, you
can transmit the Talkgroup call by pushing [PTT]
on the channel�
• Push [Call List Select] to directly display the “Call
List Select” screen in step 4 to the left�
Transmitting a call
Previous view