Operation Manual

7
dPMR™ OPERATION
7-9
Transmitting a call
D Transmitting a Revive command
A Revive command enables you to send a signal that
will revive a stunned station�
NOTE: This function is enabled only when the same
status number is set between stations�
(Menu > Signaling/Call > Call Menu)
1� Push [Menu] to display the Menu screen�
2� Push [P2 (Up)] or [P1 (Down)] to select “Signaling/
Call,” then
push [OK]�
Channel/Scan ►
Signaling/Call ►
Menu
3� Push [P2 (Up)] or [P1 (Down)] to select “Call
Menu,” then push [OK]�
Call List Select ►
Call Menu ►
Signaling/Call
4� Push [P2 (Up)] or [P1 (Down)] to select an
Individual ID, then push [OK]�
✔ Station 1 ►
✔ Group 1 ►
Call Menu
5� Push [P2 (Up)] or [P1 (Down)] to select “Revive,”
then push [PTT] to transmit the Revive command�
✔ Stun
✔ Revive
Station 1
• The stunned station is revived�
• “Success” is displayed when an acknowledgment is
received from the targeted station�
• “Failed” is displayed if an acknowledgment is not
received from the targeted station�
D Transmitting a Stun command
A Stun command enables you to send a signal
that will stun the target station� If a Stun command
is received, the target station cannot operate the
transceiver until a Revive command is received, or the
password is input�
NOTE: This function is enabled only when the same
status number is set between stations�
(Menu > Signaling/Call > Call Menu)
1� Push [Menu] to display the Menu screen�
2� Push [P2 (Up)] or [P1 (Down)] to select “Signaling/
Call,” then
push [OK]�
Channel/Scan ►
Signaling/Call ►
Menu
3� Push [P2 (Up)] or [P1 (Down)] to select “Call
Menu,” then push [OK]�
Call List Select ►
Call Menu ►
Signaling/Call
4� Push [P2 (Up)] or [P1 (Down)] to select the
Individual ID, then push [OK]�
✔ Station 1 ►
✔ Group 1 ►
Call Menu
5� Push [P2 (Up)] or [P1 (Down)] to select “Stun,”
then push [PTT] to transmit the Stun command�
✔ Ambience Listening
✔ Stun
Station 1
• “Success” is displayed when an acknowledgment is
received from the targeted station� The target station
is stunned�
• “Failed” is displayed if an acknowledgment is not
received from the targeted station�
Previous view