Operation Manual

7
dPMR™ OPERATION
7-10
D Transmitting a Broadcast call
A Broadcast call enables you to announce a voice
message to transceivers that have the same
Talkgroup ID�
(Menu > Signaling/Call > Call Menu)
1� Push [Menu] to display the Menu screen�
2� Push [P2 (Up)] or [P1 (Down)] to select “Signaling/
Call,” then
push [OK]�
Channel/Scan
Signaling/Call
Menu
3� Push [P2 (Up)] or [P1 (Down)] to select “Call
Menu,” then
push [OK]�
Call List Select
Call Menu
Signaling/Call
4� Push [P2 (Up)] or [P1 (Down)] to select the
Talkgroup ID, then push [OK]�
Group 1
Station 2
Call Menu
5� Push [P2 (Up)] or [P1 (Down)] to select
Broadcast,” then push [PTT] to transmit the
Revive command�
Write Message
Broadcast
Station 1
• “ ” and “ ” are displayed�
6� Hold down [PTT] to transmit
7� After the announcement is finished, push [Back]�
• The transceiver sends a Disconnect signal to
terminate the call�
L Only the caller station can send a Disconnect signal�
Transmitting a call
D Transmitting a Kill command
A Kill command enables you to send a signal that
will disable the target station� If a Kill command
is received, the target station cannot operate the
transceiver until it is reprogrammed�
NOTE: This function is enabled only when the same
status number is set between stations�
(Menu > Signaling/Call > Call Menu)
1� Push [Menu] to display the Menu screen�
2� Push [P2 (Up)] or [P1 (Down)] to select “Signaling/
Call,” then
push [OK]�
Channel/Scan
Signaling/Call
Menu
3� Push [P2 (Up)] or [P1 (Down)] to select “Call
Menu,” then
push [OK]�
Call List Select
Call Menu
Signaling/Call
4� Push [P2 (Up)] or [P1 (Down)] to select the
Individual ID, then push [OK]�
Station 1
Group 1
Call Menu
5� Push [P2 (Up)] or [P1 (Down)] to select “Kill,” then
push [PTT] to transmit the Kill command�
Revive
Kill
Station 1
• The target station is disabled�
“Success” is displayed when an acknowledgment is
received from the targeted station�
“Failed” is displayed if an acknowledgment is not
received from the targeted station�
Previous view