Operation Manual

7
dPMR™ OPERATION
7-16
The Trunking mode enables the transceiver to move
to another site, according to the preset Short Hunt
list*, in order to nd a site that has a higher quality
signal, or provides better services�
The Roaming function is automatically activated when
the transceiver goes out of the range, and does not
receive the downlink signal from the repeater in the
currently registered site�
Depending on the presettings, the transceiver tries to
register to the repeater that has the strongest RSSI
level in the last registered site or an adjacent site�
This roaming type takes more time than other roaming
types�
The transceiver displays the channel text after the
registration is complete�
Trunk CH 1
SiteSelect Site Lock
The transceiver displays “Out of Range” when the
transceiver cannot register to any site after searching�
Out of Range
SiteSelect SiteLock
* The valid roaming areas (up to 100) are listed on the
Site list�
D Roaming Request function
The Roaming Request function enables the
transceiver to start or resume a Roaming scan,
regardless of the error rate�
L Even if the Site Lock function is ON, and the transceiver
is locked to the currently registered site, pushing
[Roaming Request] resumes a Roaming scan�
(Menu > Trunking > Roamiing Reqst)
1� Push [Menu] to display the Menu screen�
2� Push [P2 (Up)] or [P1 (Down)] to select “Trunking,”
then push [OK]�
Signaling/Call ►
Trunking ►
Menu
3� Push [P2 (Up)] or [P1 (Down)] to select “Roaming
Reqst,” then push [OK] to start or resume the
Roaming scan�
Retention ►
Roaming Reqst ►
Trunking

Roaming Reqst
OK
4� Hold down [Back] for 1 second to return to the
standby screen�
TIP: Push [Roaming Request] to start or resume the
Roaming scan�
Roaming function (For the Trunking operation)
Previous view