User Guide

6
2
OPERATION
‘‘
General
Push to turn the power ON. A power-up alert tone will be
heard. Push again to turn the power OFF. The following
information will sequentially appear on the display.
DD
Opening text
The pre-programmed opening text and individual ID will
appear.
The individual ID consisting of a prefix code (3 digits) + a
fleet code (2 digits)+ an individual code (2 or 3 digits) will
appear.
(e.g.) If the prefix code is 200, the fleet code 2001, and the
individual code 300, the individual ID will be ‘2002001300’.
• If you are within the trunking service area, the code
(selected by [ ]/[ ]) and the received signal strength,
are displayed to indicate that communication is possible.
*In the “-TEXT-” part, the characters pre-programmed by
cloning software will be displayed.
• If you are outside of the trunking service area, or if the
system is down, will blink.
At this time, the transceiver is searching for any available
system-controlled channel.
‘‘
Calling
DD
Making a call with a memory Dial Number
Using [ ]/[ ], select one of the group codes that is
stored in the memory.
[ ]/[ ] allows you to select any group code from the 40
dial numbers.
q Select the desired dial number by pushing [ ] or [ ].
w Push [PTT] to make a call with the selected dial num-
ber.
e With ‘Calling’ displayed, the intermittent beep sound for
calling will be heard.
r With ‘Connected’ displayed, the speaker icon will appear
allowing you to start the communication. At the same
time, the count-down timer will appear to limit the com-
munication time.
(OPENING TEXT)
201 2001 300
-TEXT-
CALLING
CONNECTED
IC-F610_MPT-2.qxd 05.5.10 1:00 PM Page 11 (1,1)