User Guide

24
4
SmarTrunk II™ OPERATION
New2001
DD
Terminating a call
After completing a call, push [#] to disconnect (hang up).
IMPORTANT: If one person in the conversation terminates
a call, all participants will be cut off.
D Last number re-dial
Push [✱] 2 times to automatically re-dial the last called num-
ber.
• A high-pitched beep indicates that the number is accepted.
D Memory speed-dialling
To automatically dial a commonly used number from memory:
• Push [✱] followed by the memory location (0–9).
D Turbo SpeeDial
To automatically dial a commonly used number with one
push:
• Push one of the turbo SpeeDial keys ([A], [B], [C] or [D]).
D Programming memory speed dial
q Push and hold [✱] until you hear a high-pitched beep.
w Enter the memory location (0–9, A, B, C, D), the telephone
or subscriber number, then [1], [✱] (or [3], [✱] if for another
system subscriber).
• A high-pitched beep indicates successful programming.
• Memories [A]–[D] are used for the Turbo SpeeDial.
D System busy indication
If all channels are busy, three low beeps sound after you initi-
ate a call. Try the call again later.
D PTT dispatch operation
q Push [PTT] once (without dialling) to initiate a dispatch call.
w Begin talking after you hear three beeps (one short, high-
pitched, two very-short, low-pitched).
e Receiving a dispatch call is indicated by the same three-
beep sequence.
• It is not necessary to push [✱] to answer a dispatch call.
D Emergency call
Push [0], [✱] to initiate an emergency call.
• Contact your dealer for details.
D Clear channel alerting
If all channels are busy, the transceiver automatically begins
searching for an open channel and beeps every ten seconds.
When two short beeps (low-pitched, then high-pitched) are
heard, a channel is available. Push [✱], [✱] immediately to re-
dial the last number.
NOTE: For additional operating instructions, contact your
Dealer or System Operator.
IC-F510 Series_BIIS-2.qxd 06.7.13 1:31 PM Page 24 (1,1)