User's Manual

7
2
OPERATION
■ Turning power ON
q Push [K
I
] to turn the power ON.
• A power-up alert tone sounds for about 1 sec. and an opening
message may appear.
w If the transceiver is programmed for a start up passcode,
input digit codes as directed by your System operator.
• The keys in the diagram below can be used for password input:
• The transceiver detects numbers in the same block as identical.
Therefore “01234” and “56789” are the same.
e When the “PASSWORD
” indication does not clear after
inputting 4 digits, the input code number may be incorrect.
Turn power off and start over in this case.
■ Channel selection
Several types are available, and the channel selection
method may differ according to your system set up.
NON-BANK TYPE:
Push the
[CH Up]/[CH Down] keys to select the desired oper-
ating channel, in sequence; or,
push one of the [
CH 1] to [CH 4] keys to select these channels
directly.
BANK-TYPE:
Push [
BANK] to select the desired bank number.
AUTOMATIC SCAN TYPE:
Channel setting is not necessary for this type. When turning
the power ON, the transceiver automatically starts scanning.
Scanning stops when receiving a call or when taking the
microphone off hook.
KEY [P0] [P1] [P2] [P3] [P4]
NUMBER01234
56789
00 IC-F610EUR.qxd 01.11.28 11:37 AM Page j (1,1)