User's Manual

5
1
PANEL DESCRIPTION
• Ask your Dealer or System Operator for the out-
put power level for each selection.
TALK AROUND KEY
Turns the talk around function ON and OFF.
• The talk around function equalises the transmit
frequency to the receive frequency for mobile-
to-mobile communication.
CALL KEYS
Transmit a 5-tone call.
• Call transmission is necessary before you call
another station depending on your signaling
system.
• The [
CAL A] and/or [CAL B] keys may be avail-
able when your system employs selective
‘Individual/Group’ calls. Ask your System
Operator which call is assigned to each key.
EMERGENCY KEY
Push and hold the key to transmit an emergency call.
• If you want to cancel the emergency call, push
(or push and hold) the key again before trans-
mitting the call.
• The emergency call is transmitted one time only
or repeatedly until receiving a control code
depending on the pre-setting.
[ TA ]
[CALL]
[CAL A]
[CAL B]
[EMER]
TX CODE KEY
Select a transmit 5-tone code (station code)
channel.
TX CODE CHANNEL UP/DOWN KEY
Push to selects a TX code channel directory.
DTMF CHANNEL SELECT KEY
Push this key to select a DTMF channel.
• Push this key, then select the desired DTMF
channel using the []/[]keys.
Push and hold this key to transmit the selected
DTMF code.
NOTE (LMR ONLY): DTMF channels 7 (EMER-
GENCY) and 8 (LOG/ID) are used for ID code
and emergency code respectively, depending on
your system set up.
Ask your System Operator or Dealer about
DTMF channels 7 and 8 before using these.
C. TONE CHANNEL ENTER KEY
Push this key then input a continuous tone mem-
ory channel number via the keypad to change the
tone frequency.
[TX CH]
[CODE]
[DTMF]
[TONE]
00 IC-F610EUR.qxd 01.11.28 11:37 AM Page h (1,1)