User Manual

20
4
SELCALL/ALE OPERATION
4
ï Selective Beacon call
The Selective Beacon call allows the user determine
the signal quality between your transceiver and spe-
cific transceiver before an individual/group call. The
Selective Beacon call is also used for checking the
channel before sending TEL call.
• Sending Selective Beacon call
q Push [
∫∫
] or [
√√
] to select the channel for Selcall.
w Push [CALL] momentarily to enter the Call menu.
e Push [
ΩΩ
CLR] or [OK
≈≈
] to select ‘SEL BCON.’
•‘SELCALL,’ ‘GPS BCON,’ ‘GPS POSN,’ ‘EMER SEL-
CALL,’ ‘PAGECALL,’ ‘STATUS CALL,’ ‘SEL BCON’ are
selectable.
Convenient: Editing the intended ID
When cursor is on the call type selection, edit first
digit of intended ID (any numeric key) to move the
cursor to ID entry, then finish 4-digits (or 6-digits) ID
directly.
r Push [
√√
] to select ‘ID,’ then select your intended
ID.
• Last selected ID is displayed.
•Enter the 4-digits (or 6-digits depending on Initial set
mode setting) number of the desired ID using 10-key-
pad directly. Or push [OK
≈≈
] to enter ID selection, push
[
∫∫
]/[
√√
] to select the pre-programmed ID, then push
[OK
≈≈
] to fix the ID.
t Push [
CCAALLLL
] for 1 sec. to transmit the Selective
Beacon call.
•Before transmitting the Selective Beacon call, verify
‘SelfID’ for your own ID.
• While calling, push [CALL] to cancel the call.
• Receiving Selective Beacon call
When a transceiver receives a Selective Beacon call
with your individual ID, it automatically responds by
transmitting. The receiving Selective Beacon call is
stored in the selcall memory.
After receiving a Selective Beacon call and push [
ΩΩ
CLR] or [OK
≈≈
] to select the call, the following indi-
cation is displayed.
MES.20-01--------12:40
SEL-BCON----------1006
è-ID:2999
--2020:SELCALL
--TX:-3.200.0
è-ID:1024------------å
--SelfID:1004--------å
ç-SEL-BCON----
--2020:SELCALL
--TX:-3.200.0
è-ID:1024
--SelfID:1004
ç-SEL-BCON-----------å
--2020:SELCALL
--TX:-3.200.0
è-ID:1024
--SelfID:1004
ç-SELCALL------------å
SELCALL
USB-A
12:34
RX--3.200.0
HI