User Manual

5
31
CHANNEL/ID PROGRAMMING
■ Programming a channel
The IC-F7000 has up to 500 programmable channels
(400: regular, 100: ALE) with channel comment capa-
bility of up to 15 alphanumeric characters.
DD
Editing a channel
q While pushing and holding [OK
≈≈
], turn power ON
to enter the Initial set mode.
w Push [OK
≈≈
] to edit ‘CH LIST.’
e Push [
∫∫
]/[
√√
] to select the desired channel or
‘<add>,’ then push [OK
≈≈
].
• Push [
ΩΩ
CLR] to return the set mode menu
.
•“*” marked channel is restricted for programming. Ask
your dealer.
• When existing channel is selected
r Push [
∫∫
]/[
√√
] to select the item or push
[
ΩΩ
CLR]/[OK
≈≈
] to set the values or conditions for
each memory channel contents “Comment,” “RX
frequency,” “TX frequency,” “Call Type,” “Scan
group,” “Filter.”
• When <add> is selected
r Edit a channel number by 10-keypad, then push
[OK
≈≈
] to enter the channel programming.
• If existing channel number is entered, this operation se-
lects a desired channel directly.
ç---CH-____
-----RADTEL
è-MODE-USB
---TX-03.760.0
---RX-03.760.0
Push √ or ∫
ç---CH-12
-----RADTEL
è-MODE-USB
---TX-03.760.0
---RX-03.760.0
é-TYPE-ç-TELCALL-å
--FIL--WIDE
--SCAN-2
--DELETE-NO
--<add>---------------å
----12-RADTEL
è---15-RADTEL
-*--13-RADTEL
----14-RADTEL
SET-MODE
--CH-LIST--å
è-SCAN
--ID-LIST-
--I/O
[I/O] [Ω CLR]/[OK ≈]
[∫]/[√]