User Manual

40
6
SET MODE
6
■ Initial set mode
Initial set mode operation is used for programming in-
frequently changed values, conditions or functions.
DD
Entering set mode
q Turn the transceiver power OFF, if the transceiver is
powered ON.
w While pushing [OK
≈≈
], push [I/O] to turn the trans-
ceiver power ON to enter initial set mode.
•S
etting menu which are 7 groups appears.
e Push [
∫∫
]/[
√√
] to select the desired group.
r Push [OK
≈≈
] to edit the selected setting group.
(Eg. select ‘GENERAL’)
tPush [
∫∫
]/[
√√
] to select the desired item of the group.
(Eg. select ‘COMP’)
y Push [
ΩΩ
CLR]/[OK
≈≈
] to set the values or condi-
tions for the selected item.
u After all setting is finished, turn the power OFF and
ON again to exit the Initial set mode.
[Ω CLR]/[OK ≈]
[∫]/[√]
[I/O] [OK ≈]
GENERAL----
--DISP-TYPE--RX-TX
è-CLOCK------12:00
--COMMENT----ON
--COMP-------ç-ON-å
é-SELCALL----
--ALE--------
è-SCAN-------
--GENERAL----å
--I/O--------
SET-MODE
--CH-LIST- å
è-SCAN
--ID-LIST
--I/O
é-SELCALL--å
--ALE
--GENERAL
Push √ or ∫